Thanks a lot !
That works perfectly.

--
Nicolas

----- Original Message -----
From: "David Cary" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Monday, March 12, 2001 6:31 PM
Subject: Re: [PEDA] Printing drill marks on Gerber output


>
>
>
>
> Dear Nicolas,
>
> Have you tried making a "drill guide" ?
> Under "CAM Manager", right-click "Gerber outputs" and choose "Properties",
then
> look at the "Drill Guide" tab to see that it's enabled. While you're
there, go
> to "Advanced" and do "Position on film: Reference to absolute origin".
>
> This draws a little cross at each hole. Perhaps that would be even easier
to
> line up than a white point.
>
> There's a similar option when printing directly to a printer.
>
* * * * * * * * * * * * * * * * * * * * *

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to