I believe that in SP6 they f'd up the legend and that it is wrong.
The drill report file is correct.
Dennis Saputelli
Brad Velander wrote:
>
> Luo,
> one of my first thoughts points me toward something that has bitten
> me recently. Do you by chance have any pads that are one layer (top, bottom,
> etc.) with a drill hole? Protel99SE has a problem with these drill
> definitions where your pad is not a multilayer pad. I do not know that it
> will show up in the manner you have described but it is a possibility. What
> does your drill report say (*.drr)? In the case that I cite, the drill
> report should give the correct count of drill sizes.
>
> If you get the correct drill report and you have single layer pads
> with drill holes, change the pads to multilayer and use the padstack to
> eliminate the pads on layers that you don't want pads. (i.e. set the
> padstack pad dimensions to "0" for the layers where you don't want a pad.)
>
> Sincerely,
>
> Brad Velander
> Lead PCB Design
> Norsat International Inc.
> #100 - 4401 Still Creek Dr.,
> Burnaby, B.C., Canada.
> V5C6G9.
> voice: (604) 292-9089 (direct line)
> fax: (604) 292-9010
> email: [EMAIL PROTECTED]
> www: www.norsat.com
>
--
___________________________________________________________________________
www.integratedcontrolsinc.com Integrated Controls, Inc.
tel: 415-647-0480 2851 21st Street
fax: 415-647-3003 San Francisco, CA 94110
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *