ok I forgive you, 

Brad, I love you, man


> -----Original Message-----
> From: Brad Velander [mailto:[EMAIL PROTECTED]]
> Sent: Monday, July 09, 2001 1:23 PM
> To: 'Protel EDA Forum'
> Subject: Re: [PEDA] Layer Stackup Info.
> 
> 
> Mike,
>       please settle down.  I am sorry that you felt I was attacking you
> personally. I did not attack you or your comments, challenge you or your
> experience, I only responded to your statement quoted below.
> 
>       "The only conditions in which we specify a thickness and we only
> spec it for these layers, are controlled impedance, and where the min
> dielectric breakdown voltage is required for Bell-Core, FCC, and space
> applications."
> 
>       Now does that not sound like the situation I was describing, it
> sounds as though you were saying that you do not specify the dielectric
> (laminate) thickness except in the specified conditions mentioned.
> 
>       I cannot remember everyone's experience or abilities to best judge
> when a statement may have been written poorly or conveyed the 
> wrong idea. My
> comment was to point out the possible danger (even in non-specific
> performance requirements, i.e. basic digital circuits) of not 
> specifying the
> dielectric thickness in all cases. I hope that you can now see the issue
> which I responded to, it was not a personal attack nor was it questioning
> your abilities and I am sorry that you mistook it as such.
> 
> Brad Velander,
> Lead PCB Designer,
> Norsat International Inc.,
> #300 - 4401 Still Creek Dr.,
> Burnaby, B.C., V5C 6G9.
> Tel. (604) 292-9089 direct
> Fax (604) 292-9010
> website www.norsat.com
> 
> 
> > -----Original Message-----
> > From: Michael Reagan [mailto:[EMAIL PROTECTED]]
> > Sent: Monday, July 09, 2001 9:44 AM
> > To: Protel EDA Forum
> > Subject: Re: [PEDA] Layer Stackup Info.
> > 
> > 
> > 
> > Brad,
> > You failed to either comprehend what I  wrote or I failed to 
> > communicate
> > what I wrote.
> <SNIP>
> > 
> > Mike Reagan
> > 
> > 
> 

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to