Thanks Jim, Ian and Linden,
        nope I was really hoping there was a conversion utility for polygon
outlines.
        I just never use arcs enough to have a handle on them yet but they
are just the biggest pain to deal with since they may add a straight track
and then an arc smaller then desired, a small arc then a straight track or
if you are very very very lucky you get the arc the size you wanted. I guess
tomorrow I tell the boss that I am practicing, bill it to Protel. Grrr.
        The only way that I ever have luck with arcs in Protel is to draw a
arc, then edit and move it into place. However that doesn't work for polygon
outlines or traces.

Thanks again guys.

Brad Velander,
Lead PCB Designer,
Norsat International Inc.,
#300 - 4401 Still Creek Dr.,
Burnaby, B.C., V5C 6G9.
Tel. (604) 292-9089 direct
Fax (604) 292-9010
website www.norsat.com

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to