Thank You Max and Harry,

I have the pdf data sheet that Harry has been so kind to forward to me.
Here is the problem... with the data sheet.

The center to center spacing is .050,  even if I drop the anuallar ring to
as little as .005 which is  an .038 pad that gives me .012 between pads on
any layer.   I would have to run a 4 mil trace between pads only to acheive
a 4 mil clearance with the spacing.  Something has to be wrong here.   I
dont want to pay for 4 mil lines and space.   Am I reading the data sheet
wrong and pins one and two are located on the exterior of this connector.
The math doesnt add up for this pin to be .028 diameter

Mike Reagan

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to