Folks,

While currently checking the annular rings of a design, it appears to me as
Protel treats vias and pads differently. Following seem to be the
calculations for:

annular ring of a via = DIAMETER of pad - DIAMETER of hole
annular ring of pad = RADIUS of pad - RADIUS of hole

Can somebody confirm this? I'm using P99SE, SP6.

Thanks

Emanuel

--

%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
MPL AG                      www.mpl.ch
Emanuel Zimmermann          [EMAIL PROTECTED]
Manager R&D                 Phone: +41 (0)56 483 34 34
Taefernstrasse 20           Fax:   +41 (0)56 493 30 20

CH-5405 Daettwil
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to