******************************************************* Todays forums are sponsored by Ian Martin Limited Engineering/Technical Placement Specialists www.ianmartin.com *******************************************************
Mark, Send me a file in 99 format, I will be glad to look at it. I prefer the entire ddb file zipped Mike Reagan [EMAIL PROTECTED] > -----Original Message----- > From: Mark E Witherite [mailto:[EMAIL PROTECTED]] > Sent: Tuesday, October 02, 2001 3:00 PM > To: Protel EDA Forum > Subject: Re: [PEDA] Possible Gerber generation bug > > > Hi Tony and group, > I'm using Camtastic to view the gerbers. I just imported them > into Protel to see if the out come would be different. This PCB was > suppose to have a mix of both 2 and 4 entries which was dependent on the > net. I understand we all have dead lines to meet but if anyone has some > free time could you check this out and see if it happens to you? > Thanks > Mark > > At 10:15 AM 10/2/01 -0700, you wrote: > >...or maybe it's another Protel bug :) > > > > > > > > > -----Original Message----- > > > From: Mark E Witherite [mailto:[EMAIL PROTECTED]] > > > Sent: Tuesday, October 02, 2001 11:05 AM > > > To: Protel EDA Forum > > > Subject: [PEDA] Possible Gerber generation bug > > > > > > > > > Hi Group, > > > I'm designing a PCB that has multiple ground planes. > To make it > > > easier to assemble and rework I made the thermo relief with only 2 > > > entries. No problem Protel will let you set them in PCB editor > > > RIGHT??? I'm now viewing the board house generated Gerber and > > > guess what > > > " All plane connections have 4 entries. When back to PCB editor and > > > imported my protel generated gerbers and they all have 4 > entries. Then > > > checked my original design in the PCB editor, it still has > only 2 entries. > > > > > Mark Witherite > Assistant Research Engineer > Astronomy & Astrophysics > Penn State University > 2565 Park Center Blvd > Suite 200 > State College, PA. 16801 > email [EMAIL PROTECTED] > telephone 814 865 9839 > fax 814 865 9100 > IPC PWB Certified > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
