******************************************************* Todays forums are sponsored by Ian Martin Limited Engineering/Technical Placement Specialists www.ianmartin.com *******************************************************
Mark, I have been looking at your design all night and might have to concur with Mr. Lomax that it is full fledged bonafide bug.. After reviewing your design I could not find any overlapping or conflicting design rules, so the work you did looks fairly clean. I stripped your design to down to some basic rules and removed redundant planes so that there would no chance of confusing the program . I then made the entire board with 2 connection thermals and the gerber output was still 4 connections. That proved to be even stranger because I know for a fact that I have used 2 connection thermals on certain connectors, until I looked at my old gerbers I had sent to the board house and low and behold.....they are also 4 point. Heck I have never generated a 2 point thermal when I thought I was. Good one Mark you found a bug Regards, Mike Reagan EDSI Frederick * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
