Hi,

Is it possible to create a design without
short circuit error (sch + pcb) where two
different nets can be connected together?
For example, I need to connect two different ground
nets in one point of my PCB design and I do not
want to use R0 resistor or jumpers, I need a "wire"
that connect those nets.

Sincerely,
Juha Pajunen, Hw Engineer

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to