At 02:31 PM 11/27/01 -0400, Tim Fifield wrote:
>Is it possible to have a layer specific keep out? I want a GND trace
>connecting two components, however, there is a GND polygon between the two
>components as well. I do not want the trace to touch the polygon. Is there a
>way to do this without drawing the polygon around the track?

Two possible ways. I haven't used it much, but you can set the polygon to 
*not* "pour over same net."

You can also draw a thin track around the trace and give it the keepout 
attribute. (In the track edit dialog, not by putting it on the keepout 
layer). This will cause the polygon to keep away from the track even if it 
would otherwise pour over it.


[EMAIL PROTECTED]
Abdulrahman Lomax
Easthampton, Massachusetts USA


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to