Couple of ways to do this:

hit "q" to set imperial/metric
Reports, Netlist Status to get lengths



You can also set up a net class and design rule to check a number of
nets(tracks) have the same length.



_______________________________________________________________

Clive Broome
IDT Sydney Design Centre        Ph:         +61 2 9763 3513
8 Bayswater Dr, Homebush        Fax:        +61 2 9763 3409
Sydney,  NSW, 2127              Email:[EMAIL PROTECTED]
Australia

_______________________________________________________________








"Colin Weber" <[EMAIL PROTECTED]> on 12/19/2001 11:42:17 AM

Please respond to "Protel EDA Forum" <[EMAIL PROTECTED]>

To:   "Protel EDA Forum" <[EMAIL PROTECTED]>
cc:    (bcc: Clive Broome/sdc)

Subject:  [PEDA] Measuring Length



Folks,

Could someone help me. I want to measure the length of a net on a PCB,
and I cannot for the life of me, remember a way to easily do this?

Regards,

Colin Weber






* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to