In the options for netlist creation (Design|Create Netlist), there are two
variants of Edif 2.0 on the drop-down for Output Format on the Preferences
tab.  Have you tried these?

Regards

Andy Gulliver

> -----Original Message-----
> From: Dennis Saputelli [mailto:[EMAIL PROTECTED]]
> Sent: 03 January 2002 16:25
> To: Protel EDA Forum
> Subject: Re: [PEDA] Client99se schematics to EDIF 2.0
>
>
> my research indicates that protel schematics cannot be translated into
> anything
> i found all kinds of to/from translators but protel schematic was
> conspicuously absent
>
> bummer
>
> Dennis Saputelli
>
> [EMAIL PROTECTED] wrote:
> >
> > Hi,
> >
> > Does somebody know if there is a translator existing to convert Protel
> > client 99se schematics into a EDIF 2.0 format ?
> >
> > Thanks in advance
> >
> > De Keyser Hubert
> > ALCATEL-MICROELECTRONICS
> > westering 15
> > 9700 Oudenaarde
> > Belgium
> > Tel :  0032 55 33 27 81
> > Fax : 0032 55 33 22 64
> > email : [EMAIL PROTECTED]
> >
>

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to