At 08:25 AM 1/3/2002 -0800, Dennis Saputelli wrote:
>my research indicates that protel schematics cannot be translated into
>anything
>i found all kinds of to/from translators but protel schematic was
>conspicuously absent

As I recall the results of my research, Protel ASCII schematics are 
directly readable by OrCAD as if they were SDT schematics, the only problem 
is the libraries. The Protel libraries are in a form which seems to be 
*almost* compatible with OrCAD SDT libraries. But not quite.

[EMAIL PROTECTED]
Abdulrahman Lomax
Easthampton, Massachusetts USA

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to