I never said that Mr Scarborough had 2 neurons, so maybe I'll find "#2" in the gerber setup as directed.
Thanks for the help!! I really do appreciate it. Regards - Evan >From: "Abd ul-Rahman Lomax" <[EMAIL PROTECTED]> >Reply-To: "Protel EDA Forum" <[EMAIL PROTECTED]> >To: "Protel EDA Forum" <[EMAIL PROTECTED]> >Subject: Re: [PEDA] here we go again - film too small - HELP >Date: Thu, 21 Feb 2002 18:44:43 -0500 > >At 01:06 PM 2/21/2002 -0800, Evan Scarborough wrote: >>Greetings all, >> >>Sorry for the repeat question... >> >>I know there was just recently a discussion of this very subject a few >>weeks ago, but since I had not (yet) run into the problem I skipped over >>it. >> >>I have a 24 inch long flex board to output (very hot job) and I can't get >>99se sp6 to output the gerber files and there is no help topic (at least >>not a logical one that uses the word "film" in it). I can generate the >>drill file but no gerbers. >> >>Is there a short & fast answer to this? >> >>(Just curious about this - Why would the gerber generation process need to >>know the film size anyway? - Protel does not interface directly to any >>gerber photo-plotter that I know of and the gerber 2.xx format handles up >>to 99.xx inches - a long and slow answer to THIS question is ok) > >From the last comment we can think that Mr. Scarborough is getting a >message "film size too small," in which case one possible source of this >problem has already been mentioned and there is also the possibility of >increasing the film size in the gerber setup properties. > >The other possibility is that Mr. Scarborough does not know how to set up >gerber definitions, but my wife is at the door saying it is time to go.... > >[EMAIL PROTECTED] >Abdulrahman Lomax >Easthampton, Massachusetts USA _________________________________________________________________ Send and receive Hotmail on your mobile device: http://mobile.msn.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
