Radek,
        assuming you are talking about P99SE, the IPC 356 netlist can be
generated as a CAM output in PCB. When generating you cam files you can
insert a Testpoint report. As a sub selection within the test point report,
you may select IPC 356. After generating the file, exporting it is done in
the same manner as any file you're exporting.

Sincerely,
Brad Velander.

Lead PCB Designer
Norsat International Inc.
Microwave Products
Tel   (604) 292-9089 (direct line)
Fax  (604) 292-9010
email: [EMAIL PROTECTED]
http://www.norsat.com

See us at Booth 323 at Satellite 2002 in Washington, DC March 6-8.



-----Original Message-----
From: Radek Kristof [mailto:[EMAIL PROTECTED]]
Sent: Monday, February 25, 2002 2:49 PM
To: '[EMAIL PROTECTED]'
Subject: [PEDA] IPC 356 netlist


Hi all,
I have a simple question:
Is it possible to export IPC 356 netlist directly from Design Explorer 99SE?
If not, is there any other way to do it.
Thanks

Radek Kristof

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to