Aah ha! That fixed it. Sort of.

I've only just worked out how to maximise programs across two monitors (as
well as enabling "Maximise across both desktops" I also have to hold down
CNTRL whilst maximising a window. I used to "restore" a program window and
stretch it to fill both monitors.

Now that I have Protel maximised the annoying "sticky" scrolling behaviour
only persists when the mouse is pushed past the top edge of the workspace.
Left, right and down work well now, just not up, it's still a bit "sticky".

It's better than Re-centre though, thanks Brian.

Tom.


-----Original Message-----
From: Brian Sherer [mailto:[EMAIL PROTECTED]]
Sent: Thursday, 23 May 2002 12:16 AM
To: Protel EDA Forum
Subject: Re: [PEDA] Autopan in PCB (99SE)


Be sure the active screen is maximized, too; at times it may appear
to be maximized but is not. I've seem some unusual effects when
the cursor reaches the edge of a non-maximized screen in PCB and SCH.

Brian

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to