Do an Edit-Select-ConnectedCopper and you'll get a highlighted poly plane for everything that IS connected. It will be obvious what IS NOT connected and you can populate that with stitching vias or pads.
Tony -----Original Message----- From: Katinka Mills [mailto:[EMAIL PROTECTED]] Sent: Friday, August 09, 2002 9:42 AM To: Protel EDA Forum Subject: [PEDA] Highlighting dead copper on P99SE Hi all, Quick Q, I have a 2 layer PCB with top and bottom ground planes (like to balance up my copper) how do I hilight dead copper, I do not want to remove it, just need to see it so I can add vias to make it not dead :o) Should be easy, but the help menu has no topic on dead copper (does not even find the word dead ?? ) Regards, Kat. ********************************************** K.A.Q. Electronics. Electronic and Software Engineering. Perth, Western Australia. Ph +61 (0) 419 923 731 ********************************************** ************************************************************************ * Tracking #: ACB1799E047E80499CA7990312B01378BD77700C * ************************************************************************ * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
