Tony,
        if you read my message following this one that you replied to, you
will realize that I had misread the original message. Your method would
probably work as an inversion to the original request, highlighting the
connected polygon.

Sincerely,
Brad Velander.

Lead PCB Designer
Norsat International Inc.
Microwave Products
Tel   (604) 292-9089 (direct line)
Fax  (604) 292-9010
email: [EMAIL PROTECTED]
http://www.norsat.com


-----Original Message-----
From: Tony Karavidas [mailto:[EMAIL PROTECTED]]
Sent: Friday, August 09, 2002 11:02 AM
To: 'Protel EDA Forum'
Subject: Re: [PEDA] Highlighting dead copper on P99SE


Yeah, I guess I was assuming the net connected to her power polygon has
a 'majority' of it connected.  

If she does what I indicated, it will be obvious what parts of her
polygon pour (which is a outer layer ground plane) are not actually
connected. It will also be obvious if two or more large sections are not
connected to each other (but a DRC should point that out quickly too) 

Tony



************************************************************************
* Tracking #: B43F029E68221540AECE9E243F69BAF7DD9B5BEA
*
************************************************************************

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to