Tony,
        that will only select copper connected to the single net that you
click on. You would have to individually click every net on the board to
highlight all copper other than the "dead copper".

        I did a quick test trying to globally select all copper that was "no
net", it failed miserably. It was actually selecting copper that was
assigned to other nets. Don't know why but I didn't reply to Kat because my
test had failed trying to globally select "no net" copper. I had two pieces
of copper that were intentionally set to "no net", my global selection
selected 5 pieces of copper, three were on another net. I think it is one of
those Protel "features".

Sincerely,
Brad Velander.

Lead PCB Designer
Norsat International Inc.
Microwave Products
Tel   (604) 292-9089 (direct line)
Fax  (604) 292-9010
email: [EMAIL PROTECTED]
http://www.norsat.com


-----Original Message-----
From: Tony Karavidas [mailto:[EMAIL PROTECTED]]
Sent: Friday, August 09, 2002 10:07 AM
To: 'Protel EDA Forum'
Subject: Re: [PEDA] Highlighting dead copper on P99SE


Do an Edit-Select-ConnectedCopper and you'll get a highlighted poly
plane for everything that IS connected. It will be obvious what IS NOT
connected and you can populate that with stitching vias or pads.

Tony



************************************************************************
* Tracking #: 9E286F365DB17543BFF96E0C042EFFA80ACA1686
*
************************************************************************

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to