I just tried to simulate a multichannel board composed of a main sheet and 4
subsheets, each a copy of an amplifier connected by the main sheet.  While
the individual amplifier simulates fine (as a separate single sheet
simulation, with source added there) and the .nsx file is generated
perfectly (and inspected carefully) for the active sheet and subsheets, the
simulation quits immediately with no output and no error.  The .sdf is
empty.  The simulation is setup as the simplest AC small signal and
operating point analysis, source is ok, no errors in creation, etc..

Has anyone any experience with this?

thanks in advance.

Tim Hutcheson



************************************************************************
* Tracking #: 7A7B5126B37D5E40821AD99D769E3DA5D71D23FE
*
************************************************************************

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to