Hi All,
I want to apply a matched-length constraint to the signals
connected to the bus. In the Protel Design Rule dialog, there are mainly 2
parameters to specify, one is Tolerance (whose purpose is obvious) and the
other is Connection style. In connection style there are three options 1) 90
degree 2) 45 degree and 3) Rounded. Alongwith them there are also options of
Amplitude and Gap.I couldn't understand these options so Can someone tell me
how these options are utilized effectively while routing a bus running at
66MHz.
Regards,
ADEEL MALIK
************************************************************************
* Tracking #: 0E65D282D6969F409D601E4E0E422F8499FF2F09
*
************************************************************************
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
