Hi all, I've had 99SE for almost a year but have used it very little. I am trying to use it now to make a composite of two boards I did in PCB 2.8 (still my favorite). I have a 750MHz dual-processor Dell system and 99SE just stops dead in the water when it is doing things, especially trying to figure out the inner plane connections which it seems to do way too much. The drawing is painfully slow. I can't believe everyone using 99SE has a 2GHz or better processor but this is completely unusable in my estimation on my computer. Are there tricks to get a decent amount of performance out of this software so I don't have to twiddle my thumbs for 5 minutes every time I change something? Thanks,
-Bob -------------------------------------------------------------------- Robert Ritchey Quest Engineering & Development 1328 East Cottonwood Lane Phoenix, AZ 85048-4765 Tel: (480) 460-2652 FAX: (480) 460-2653 E-Mail: [EMAIL PROTECTED] E-Mail: [EMAIL PROTECTED] E-Mail: [EMAIL PROTECTED] E-Mail: [EMAIL PROTECTED] WWW: www.QuestEngDev.com/ WWW: www.Smart-Fly.com/ -------------------------------------------------------------------- ************************************************************************ * Tracking #: 0D2CAF202E06AE4BB91E983250FF4FA7A9F98A54 * ************************************************************************ * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
