----- Original Message -----
From: "Robert M. Wolfe" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Sunday, November 03, 2002 1:22 PM
Subject: Re: [PEDA] Silkscreen over pads


> To All,
> Just a thought.
> If there is no means of DRC'ing silkscreen
> with repsect to pads (or anything else for that matter)
> then WHY is it that Protel runs a DRC (which does
> take a few seconds) eveytime a Ref Des on Silkscreen
> layer is moved???? It's not an electrical item yet
> I see it annalizing VCC everytime I move a Ref Des
> on a part that is has connections to power (most parts)
> on a big board where planes are complete etc.
> Sure makes ya wonder.
> Seems to waste a bit of time for checking what
> at that moment????
> Bob Wolfe

I'd imagine that Protel will be programmed such that any change to a part
(including it's silkscreen) will cause a DRC to occur.

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:proteledaforum@;techservinc.com
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:ForumAdministrator@;TechServInc.com
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@;techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to