I have noticed that the "NOT" indicator or Bar over the signal name
'feature' in Protel Schematic plots incorrectly on the HP Plotter when
printing my schematic. Have any of you seen this before and what is causing
it? How can I work around this problem?


Bill Brooks 
PCB Design Engineer , C.I.D., C.I.I.
TITAN SYSTEMS CORPORATION
DATRON WORLD COMMUNICATIONS DIVISION
3030 Enterprise Court, Vista, CA 92083 
Email: [EMAIL PROTECTED]
Website: http://www.dtwc.com/
Tel: (760)597-1500 Ext 3772 Fax: (760)597-1510 

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to