I know that if I do not have all the schematics open for the project and print all the schematics the "NOT" bars are all messed up, whey to long, wrong spots .... If all the schematics are open it prints fine
-----Original Message----- From: Brooks,Bill [mailto:[EMAIL PROTECTED]] Sent: Wednesday, November 20, 2002 10:49 AM To: 'Protel EDA Forum' Subject: [PEDA] Protel Schematic - Inverted signal name "NOT" bar over the text p lots very LONG and not to scale I have noticed that the "NOT" indicator or Bar over the signal name 'feature' in Protel Schematic plots incorrectly on the HP Plotter when printing my schematic. Have any of you seen this before and what is causing it? How can I work around this problem? Bill Brooks PCB Design Engineer , C.I.D., C.I.I. TITAN SYSTEMS CORPORATION DATRON WORLD COMMUNICATIONS DIVISION 3030 Enterprise Court, Vista, CA 92083 Email: [EMAIL PROTECTED] Website: http://www.dtwc.com/ Tel: (760)597-1500 Ext 3772 Fax: (760)597-1510 * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
