At 04:56 PM 12/7/2002, Andrew Jenkins wrote:

When I "grab" an entity within the P99SE Schematic editor, specifically one such as a wire or wire-end, I have a difficult time actually attaching my cursor to the entity, unless I have magnified the local area to an often unacceptable zoom level.
Electrical grid setting? Snap grid setting? Are the objects on the snap grid?

Protel is actually especially good at allowing useful edits at low zoom, so something is probably set badly....

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *


Reply via email to