As BrianG points out, the answer to your question depends a lot on your application. Try searching the web for high voltage supplies ... the following may offer some starting points ...
http://www.powerdesigners.com/cgibin/design_center/Subject http://www.kronjaeger.com/hv/ http://www.high-voltage-assoc.com/cgi-bin/ultimatebb.cgi http://www.geocities.com/CapeCanaveral/Lab/5322/hv2.html http://www.epanorama.net/links/psu.html -----Original Message----- From: Brian Guralnick [mailto:[EMAIL PROTECTED]] Sent: Thursday, 16 January 2003 6:33 p.m. To: Protel EDA Forum Subject: Re: [PEDA] SV: High Voltage power supply 8Kv at what current? Pulsed, or continuous? How fast doest it need to build a charge? I'm thinking along the lines of a small transformer switched with diode / cap multiplier at the output. Something similar to an air ionizer circuit. You'll need to use conformal coating all over your PCB. Will the output be current limited by a series resistor? ____________ Brian Guralnick [EMAIL PROTECTED] ----- Original Message ----- From: "Peder K. Hellegaard" <[EMAIL PROTECTED]> To: "Protel EDA Forum" <[EMAIL PROTECTED]> Sent: Wednesday, January 15, 2003 5:16 PM Subject: [PEDA] SV: High Voltage power supply > 8kV is needed...... > > > > -----Oprindelig meddelelse----- > Fra: Brian Guralnick [mailto:[EMAIL PROTECTED]] > Sendt: 15. januar 2003 23:03 > Til: Protel EDA Forum > Emne: Re: [PEDA] High Voltage power supply > > > How high? > > 25Kv, 100Kv? > > Or, 600v. > > In both cases, a flyback will probably be the cheapest & most cost > effective. > > > ____________ > Brian Guralnick > [EMAIL PROTECTED] > > > ----- Original Message ----- > From: "Peder K. Hellegaard" <[EMAIL PROTECTED]> > To: "Protel EDA Forum" <[EMAIL PROTECTED]> > Sent: Wednesday, January 15, 2003 9:19 AM > Subject: [PEDA] High Voltage power supply > > > > Anyone who knows where to find schematics for high voltage (low current) > > power supplies, preferably designed with a series of voltage doublers ? > > > > > > Thanks in advance...... > > > > > > > > Peter > > > > > > > > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *