Dennis,
I could also contribute that in the imperial world our local suppliers seem to
have 0.094" as their standard routing tool. That is a very close equivalent to 2.4mm.
Sincerely,
Brad Velander.
Lead PCB Designer
Norsat International Inc.
Microwave Products
Tel (604) 292-9089 (direct line)
Fax (604) 292-9010
email: [EMAIL PROTECTED]
http://www.norsat.com
> -----Original Message-----
> From: Ian Wilson [mailto:[EMAIL PROTECTED]
> Sent: Saturday, March 15, 2003 9:41 PM
> To: Protel EDA Forum
> Subject: Re: [PEDA] tab route 2.4
>
>
> On 04:36 AM 16/03/2003, Dennis Saputelli said:
> >do you really mean '2.4mm rout'
> >not '2.54mm route' ?
>
> Dennis,
> A standard router bit in use on most PCB makers I know is 2.4mm (not
> 2.54mm). This is a good tool to use as it supports a good
> feed rate - much
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
