20/06/2003 10:40:32, [EMAIL PROTECTED] wrote:

>can't screen single pin nets ( very embarrasing ), 

Er, are you sure? Just go into the error matrix, and set each of the 
'unconnected' boxes to a warning. 
Any point where you think that unconnected is OK, stick a No-ERC on 
the schematic, and job done. (Since my customers tend to require a test 
point on every net, all nodes go to at least 2 places, so unconnects are, 
by definition, banned)

Steve





* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to