Tim, This may be asking the obvious, but how are you evaluating this, on a print preview or the pcb? Have you checked closely by enlarging the area in question? It could just be you have the clearance constraints set tightly enough to make it "appear" to be in direct connect. Also, what is the relief conductor width set to? If it is quite large, it might appear as a direct connect. This width is set in the design rule and is separate from the conductor width setting you are asked for when placing a polygon plane. It is possible to have the same polygon (same net) have two different connect styles on the same layer. This is done in the design rules also. Good luck, I hope this helps.
Dan Enslen ti -----Original Message----- From: Tim Fifield [mailto:[EMAIL PROTECTED] Sent: Thursday, January 15, 2004 10:50 AM To: Protel EDA Forum Subject: [PEDA] Polygon Connect question It appears that my polygons are in direct connect mode when my design rules state that they are in relief mode. Is there something I'm missing? Tim Fifield * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *