Ian,
        This sounds like it could be the old problem that shows up when you
do not have a valid printer configured. After installing the service pack
did you already configure your printer(s)?  Are they configured the same as
they were previously?
        I just remember P99Se doing something similar to this if you lost
your printer configs that it was expecting to see.

Sincerely,
Brad Velander
PCB Designer
Xantrex Technology Inc.
(direct) (604) 415-4054
(general) (604) 422-8595 ext. 4054
(fax) (604) 422-1591


-----Original Message-----
From: Ian Middleton [mailto:[EMAIL PROTECTED] 
Sent: August 11, 2004 8:33 AM
To: Protel EDA Forum
Subject: [PEDA] XP SP2 stop Protel 99SE working ??


Dear all,

I am seeing Protel 99SE hanging with "scanning documents" when opening a
ddb file after having installed XP SP2.

Will investigate further, but SP2 looks a prime candidate to have caused the
problem.

ian



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to