Hey Brian,

I had meant to respond to this message but somehow got sidetracked.

The I/O setup table isn't accessible yet but the rest of the window is. Here's 
what you can do (and you'll need to do it for both the input and output tabs):

Select all with Command-a and then press the delete button. You'll probably get 
an alert but you can just delete these paths left over from the other system.

Then press the "Default Paths" button. This will create the proper input paths 
(or output paths, depending upon which tab you're in).

When you return to the session, it's likely that your outputs will all say "No 
Output." when you're focused on any track's output assignment, route the mouse 
to the voiceOver cursor. Now you'll need to perform this next task with a 
physical mouse button or track pad. Hold down the Option key and click. Use 
VoiceOver to navigate to your first stereo bus (analog 1-2 or whatever) and 
press Return. this will globally set all outputs to the same path.

HTH,

Slau

On Dec 30, 2010, at 12:58 PM, Brian Casey wrote:

> Hi all,
> 
> Some of this is just my lack of knowledge in the software in general, but 
> firstly, in setup and I/O, I'm having problems navigating and I think there 
> are parameters that are inaccessable. I'm just working on a project imported 
> from a HD rig, and in the mix window, the session is still showing up the 
> output and input paths from that HD rig. When I try to change them, the I/O 
> paths for my 003 I'm working with at the moment aren't showing up, and I 
> thought that I would be able to get them to show up in the setup and I/O 
> window. They have shown up to an extent, but when I click OK, ProTools tells 
> me I haven't set all necessary parameters for the output path or which ever 
> I'm trying to adjust.
> 
> As a separate issue, I'm using a borrowed 003 on a Macbook pro from my 
> college, and it has drivers for an M box mini installed. I would have thought 
> with the 003 connected and recognised, when I open a new session, any track 
> in it would have the 003 input and output paths available for routing, 
> however this doesn't seem to be the case. It only seems to be showing one 
> pair of stereo outs or their mono left and right, and the same for input, 
> just one stereo pair, and an  S/PDIF stereo pair. So even working from a new 
> session and not just in my imported session from the HD system I can't seem 
> to establish all the routing paths from and to the 003. In fact, though I am 
> now thinking that the I/O setup window isn't working for me, I actually got 
> the right analogue inputs and outputs for the 003 when in the imported HD 
> session, but only had the few stereo pairs and their mono equivalents 
> mentioned above.
> 
> Strange stuff, apologies if I'm asking questions that are in the users 
> mannual, but I haven't made it all the way through the general ProTools one, 
> and only have borrowed the 003 in the last few days.
> 
> Maybe its just that the I/O window isn't fully accessible yet and the other 
> problems are to do with drivers or something.
> 
> Thanks for reading,
> Brian. 

Reply via email to