Hi Ronald,

I'm afraid I don't have an answer for you yet. Funny, with this whole Pro Tools 
9 being able to utilize Core Audio, I must admit, it kind of stumps me a 
little. Before this, it was very straight forward: Pro Tools used the I/O of 
the attached Digidesign interface and that was that. For me, it's still fairly 
straight forward in that I've thus far only used either HD interfaces which 
were automatically recognized, or a 003 which was also automatically 
recognized, or the Core audio aggregate device that wasn't recognized at first 
but somehow became active quite suddenly due to, I'm sure, my ignorant 
fumblings around the first time I looked at the Audio/MIDI setup. I think some 
other people on the list have given it more time and thought and could probably 
give a better answer.

Best,

slau

On Feb 11, 2011, at 6:36 AM, RvR wrote:

> Hi guys,
> Since you are talking about outputs and all you don't mind me throwing in 
> some dummy questions also?
> While struggling through the reference guide for PT 9 I tried to get some 
> sound out it already. I use PT 9, internal audio of my Mac Pro for the time 
> being and a set of speakers connected to the line out jack.
> I selected the Aggregate device in the Hardware setup for my internal audio 
> chip. Once I got some sound out of it, but came from the internal speaker 
> only. Don't know what I did after that but cannot get any sound anymore at 
> all.
> The i/o settings are as follows:
> Input:
> Don't see any to be honest, think defaults are active here.
> Output:
> Controller Meter Path: Out 1-2
> Audition Path: A1-2
> Default Output Bus: Out 1-2
> 
> On the track input and output settings all the above are selected. 
> So how can I configure the sound comes out of the line out to my external 
> speakers? If that's possible at all.
> a man's got to srart somehwere right? LOL
> Thanks,
> Ronald

Reply via email to