Slau,
You bring up a very good point that raises a question I've now had for
several months. I didn't wanna post though in fear of me looking totally
stupid. What I've been doing is to record, say, 3 backing vocal tracks.
Then, I'd take the output path popup button, and instead of leaving it set
on my interface, I'd switch it over to a bus. Let me be very clear. I'm
doing this with the output path selecter, not with the sends. Now,
basically, I then create a stereo auxiliary track, and I set the input path
popup button to the same bus that I set for the output on the 3 vocal
backing tracks. Now, obviously, those 3 backing vocals are being played
through that AUX track. Then, on the AUX track, I'll pop a reverb, say on
insert A. I set it the way I like, and then those 3 vocals have reverb.
The thing is, doing it this way, if I move my output volume slider within
that AUX track up or down, it's going to adjust the volume of those 3
vocals. So, my question is, what if I didn't want to have that AUX track
contain the vofals. What if all I wanted it to have was the reverb effect,
and nothing more? This way, I could send just the reverb effect from the 3
vocals to an AUX track, then turn that AUX track up or down only to increase
or decrease the amount of reverb without screwing with the volume level.
How would be the best way to do this in the example I'm giving? Is this
something I'd have to go into the output window button on the audio tracks?
I confess, I've never looked inside the output window, so I don't totally
know what all is in there. Guilty as charged.
Chris.
--
You received this message because you are subscribed to the Google Groups "Pro Tools
Accessibility" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
