Hello,

I changed to ttyS0 but the problem persists. Here it is the output.

=======
CPU:   e300c3, MPC8313E, Rev: 21 at 333.333 MHz, CSB:  166 MHz
Board: Freescale MPC8313ERDB
I2C:   ready
DRAM:  128 MB
FLASH:  8 MB
NAND:  32 MiB
In:    serial
Out:   serial
Err:   serial
Net:   TSEC0, TSEC1 [PRIME]
Hit any key to stop autoboot:  0
Speed: 100, full duplex
Using TSEC1 device
TFTP from server 192.168.0.1; our IP address is 192.168.0.2
Filename 'uImage'.
Load address: 0x1000000
Loading: #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         ###
done
Bytes transferred = 2010252 (1eac8c hex)
## Booting image at 01000000 ...
   Image Name:   Linux-2.6.34
   Created:      2010-09-23  15:54:10 UTC
   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
   Data Size:    2010188 Bytes =  1.9 MB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
=======

Is there any specific powerpc configuration that might be done? I am
using the kernel configuration file from the mainstream. Is it an
issue?

Best regards,

Flavio



2010/9/23 Gary Thomas <[email protected]>:
> On 09/23/2010 12:42 PM, Flavio de Castro Alves Filho wrote:
>>
>> Hello,
>>
>> I am currently trying to build a ptxdist application for the Freescale
>> PowerPC MPC8313 RDB board.
>>
>> I configured the linux kernel 2.6.34 using the
>> 83xx/mpc8313_rdb_defconfig configuration file and compiled with the
>> gcc 4.3.2 from the OSELAS toolchain project for the powerpc-603e.
>>
>> All the compilation works fine, from both kernel and root filesystem.
>> When I load the kernel to the board, the kernel is correctly load and
>> uncompressed but the boot does not occur. After the uncompression, it
>> hangs. The kernel is loaded in the memory position 0x1000000 and the
>> bootargs is "rw console=ttys0,115200 root=/dev/nfs".
>>
>> Does anybody have any idea about what is causing this problem?
>
> The console device should be ttyS0 (upper case matters)
>
> --
> ------------------------------------------------------------
> Gary Thomas                 |  Consulting for the
> MLB Associates              |    Embedded world
> ------------------------------------------------------------
>

-- 
ptxdist mailing list
[email protected]

Reply via email to