Hiya

Do not do any high tension / voltage tests if you have a pacemaker!!!

I assume you held a plug lead close to the engine block to see for a
spark.

The first things to check (in no particular order!)

Test you have 12V through the ignition to the coil
Make sure the engine is earthed properly
Check the rotor cap is fitted (not as daft as it sounds!)
Check the continuity on the wires from the coil to points /
distributor
Make sure the connectors / plugs etc are actually connecting

Make sure the coil is not open or short circuit (should an amount of
resistance) - or borrow another coil

Just because they are new HT leads - do not assume they are working
ok.

Best regards

James T
Q2 - 002


On 16 Sep, 18:42, Arn1905 <[email protected]> wrote:
> Pretty much finished the Frst conversion on the 2+2, went to start it
> up but there is no spark.
> Brand new ht leads and plugs.
>
> Is there anything i can test/try before i start tracing back all of
> the wiring?
>
> Thanks
>
> Arnie

--~--~---------~--~----~------------~-------~--~----~
  You received this message because you are subscribed to the Google Groups 
"Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/quantumowners?hl=en

IMPORTANT NOTE: All information presented herewith is provided on an "As Is" 
basis, without warranty or the implication thereof. Neither the Quantum Owners 
Club nor the individuals associated with the Quantum Owners Club or in the 
preparation of the above information shall have any liability to any person or 
entity with respect to liability, loss, or damage caused or alleged to be 
caused directly or indirectly by the instructions contained within this or 
related message(s).
-~----------~----~----~----~------~----~------~--~---

Reply via email to