Now getting the spark and its up and running :D

Went over several things, replaced the coil and edit unit, checked
over some loose wires, made better connections and grounds and now is
up and running. could have been a combination of a few.

Thanks alot for the help.

One last thing, the throttle pedal on the 2+2, was the plate that
rests against the top of it bent so that the cable has enough movement
and was not tight?



On Sep 18, 6:13 pm, Jim Hearne <[email protected]> wrote:
> The edis module should generate a spark independently of the ecu.
> It only needs the the signal from the CPS and power for it to start
> making sparks.
> I think the power to the Edis module is separate to that for the coil
> pack so check for that as well, also that the edis module is earthed.
>
> Does the fuel pump prime when you turn the ignition on ?
>
> Jim
>
> Arn1905 wrote:
> > Pretty much finished the Frst conversion on the 2+2, went to start it
> > up but there is no spark.
> > Brand new ht leads and plugs.
>
> > Is there anything i can test/try before i start tracing back all of
> > the wiring?
>
> > Thanks
>
> > Arnie
--~--~---------~--~----~------------~-------~--~----~
  You received this message because you are subscribed to the Google Groups 
"Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/quantumowners?hl=en

IMPORTANT NOTE: All information presented herewith is provided on an "As Is" 
basis, without warranty or the implication thereof. Neither the Quantum Owners 
Club nor the individuals associated with the Quantum Owners Club or in the 
preparation of the above information shall have any liability to any person or 
entity with respect to liability, loss, or damage caused or alleged to be 
caused directly or indirectly by the instructions contained within this or 
related message(s).
-~----------~----~----~----~------~----~------~--~---

Reply via email to