Any progress ?
Jim
On 07/06/2010 10:19, geoff ward wrote:
Hi all and thanks again for all the helpful suggestions.
Steve and I have checked and double checked through all that has been
suggested, every thing seems to work as it should individually. The
idle speed control vale has been thoroughly cleaned again and checked
to see that it works, then refitted with a new gasket and that it
receives input, electronically, from its plug. Steve has checked all
the connections with his testing equipment, it's all beyond me!, and
it all works. We have reset the ECU yet again, despite spending all
day Saturday trying to get it to run properly, it still has the same
problem.
Thank you Steve for all the time and effort you have put in so far to
try and fix it.
So if any of you have any further suggestions, we would be pleased to
hear them, as Carole and I are getting worried now, with only one
weekend to go before we head to Scotland.
Yours hopefully Geoff.
On 1 June 2010 22:59, geoff ward <[email protected]
<mailto:[email protected]>> wrote:
Thank you to all for your help and advice, I will do a bit more
checking and cleaning of contacts etc tomorrow. The strangest
thing,as Steve mentioned in his original post, is that the engine
idles perfectly
at around 900 - 1000 rpm (according to the XR2 rev counter) when
you first start it up. I have followed the method for resetting
the ECU 4 times know and it has had good idle speed every time for
the first stage of the reset, ie allow to idle for 10 -15 mins (DO
NOT TOUCH THE THROTTLE) it only goes all wrong after that! As soon
as you start to drive it, that's when it wont idle properly anymore.
Carole say thank you all.
Regards, Geoff.
On 1 June 2010 12:29, Steve Kodz <[email protected]
<mailto:[email protected]>> wrote:
We're getting a very bad idle with the Zetec in Carole's 2+2.
With the idle
speed control valve connected from cold it will idle nicely at
around
1000rpm, if just left to idle and warm through. However if
you rev, or
drive that car the best idle to can get is between 2-3,000
rpm, which isn't
great :( The car also drives badly, having hesitation and
then you fight
the engine on the over run.
It is a lot better with the ISCV disconnected, but still not
great. The
idle is still a bit high, being around 1,200 rpm and it still
doesn't drive
that great.
We've tried resetting the ECU to re-program it and Geoff's
cleaned all the
electrical contact and the ISCV. Any ideas what else needs to
be done to
get this ready before the HHII?
Regards,
Steve
--
www.h4-turbo.co.uk <http://www.h4-turbo.co.uk/>
www.quantumowners.co.uk <http://www.quantumowners.co.uk/>
www.quantumcars.co.uk <http://www.quantumcars.co.uk/>
www.quantumheritage.co.uk <http://www.quantumheritage.co.uk/>
--
You received this message because you are subscribed to the
Google Groups "Quantum Owners Group" group.
To post to this group, send email to
[email protected]
<mailto:[email protected]>
To unsubscribe from this group, send email to
[email protected]
<mailto:[email protected]>
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided
on an "As Is" basis, without warranty or the implication
thereof. Neither the Quantum Owners Club nor the individuals
associated with the Quantum Owners Club or in the preparation
of the above information shall have any liability to any
person or entity with respect to liability, loss, or damage
caused or alleged to be caused directly or indirectly by the
instructions contained within this or related message(s).
--
You received this message because you are subscribed to the Google
Groups "Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an
"As Is" basis, without warranty or the implication thereof. Neither
the Quantum Owners Club nor the individuals associated with the
Quantum Owners Club or in the preparation of the above information
shall have any liability to any person or entity with respect to
liability, loss, or damage caused or alleged to be caused directly or
indirectly by the instructions contained within this or related
message(s).
--
You received this message because you are subscribed to the Google Groups "Quantum
Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is"
basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor
the individuals associated with the Quantum Owners Club or in the preparation of the
above information shall have any liability to any person or entity with respect to
liability, loss, or damage caused or alleged to be caused directly or indirectly by the
instructions contained within this or related message(s).