Hello, I went throught the IVA last Summer with an Xtreme, hopefully the following helps;
1) My examiner decided that the existing side indicators were not visible 5 deg out and down from the rear of the vehicle and the exemption that had been applied (due to caterhams) was no longer applicable. (Personally I did not agree, but you can't really argue) As a result this consituted a fail for me (along with a number of other things !) My solution was a pair of LED indicators stuck to the rear of the rear of the front wheel arches (on the Windscreen posts would have worked, but I removed my windscreen)- see later... I used a rubber grommer to fill the existing holes and some light 2 core wire to effectively extend through the engine bay, along the front supports and onto the wheel arches - rather time comsuming but it worked. (you MUST remove the originals or black them out) Ensure you have plenty of tywraps to ensure the cable (indeed all cable) is supported etc. I used waterproof glue from B&Q to fix it on the arches to avoid additional holes - take the glue with you - I was asked to prove it was suitable. ( it is also easy to remove later.....) I think the LED's were about £19 from europarts, but may available elsewhere. No issue with LEDS for me. 2) Boot hinges - They don't protrude the 5mm so should be OK, however I had already softened the edges with a small file. 3) Check your fog light switch, the supplied one I had was for fronts and I had to change ( and the colour was wrong) No other switches were a problem 4) Sierra set-up is OK, provided all brakes are equally new or used (If you can, drive to the test the long way and give them some exercise) If you have a brake balance bar, but it must be fixed (welded I think) in order to pass. I think the simple test for balance is that if you do an emergency stop the rear wheels should not lock before the front - I am NOT an expert, a garage with MOT test could check for you. 5) No idea, advice I have had from others is paying a garage is worth, it should ensure you don't fail emissions etc. I put it off for a while, then paid up - I should of earlier as they got 17 more BHP at the same time !!! Also - an easier pass is a car with no doors (can't adjust mirrors with the doors on), no roof (covers the fuel inlet),no windscreen (Edges of uprights too sharp, wipers cant clean the whole screen (unless you have updated the system). Check your stamped in VIN (not the plate) is on the offside now- it was nearside front post for me.. The DOT3 sticker near the brake fluid.. Wiring - the FOG lights cannot come on with the side lights, only the mains (my loom did originally - I added a relay to resolve this) Last one - My tester decided the brake cylinder on the front wheels was not rounded enough when checked from the rear (?<>>(&^%&*(^^%££""££ $£***) I added some old rubber gaitors and tywraps to cover this to avoid the risk of weakening the system (Standard ford hubs) On the positive side, the testers were helpful - I think they enjoy the tests rather than dealing with people who have been sent there by the DVLA / police for 'other' reasons. Where are you located, I would be happy to have a look over the car if you are close (I am in Hertfordshire) Good luck, Andrew On Mar 10, 11:50 am, Ian Harrison <[email protected]> wrote: > Andy would be a good source of information as I believe he has been through > the IVA test with his Xtreme. > > Calling Andy to the list! :-) > > Ian > > On 10 March 2011 07:23, nigelp <[email protected]> wrote: > > > Can't help you with all and mine was SVA about 4 years ago, but here's > > what I know/ believe: > > 1. Not sure what you mean - front or rear - the rears have indicators > > and the fronts are on stalks from the nose cone, also indicators on > > sides of the scuttle. To my knowledge no others are required. > > > 2. My boot hinges were OK as standard, I did just break the sharp > > edges with a fine file. Both mine and brothers passed OK - same > > tester. I would break the egdes and go for it, if he flunks it ask > > him for advice on what it would take to pass. > > > 3. Don't believe any ID necessary, just have tpo be visible. > > > 4. I had no issues with brake balance on standard Sierra disc front/ > > back set up. > > > Hope this is some use. > > > Nigel > > > -- > > You received this message because you are subscribed to the Google Groups > > "Quantum Owners Group" group. > > To post to this group, send email to [email protected] > > To unsubscribe from this group, send email to > > [email protected] > > For more options, visit this group at > >http://groups.google.com/group/quantumowners?hl=en > > > IMPORTANT NOTE: All information presented herewith is provided on an "As > > Is" basis, without warranty or the implication thereof. Neither the Quantum > > Owners Club nor the individuals associated with the Quantum Owners Club or > > in the preparation of the above information shall have any liability to any > > person or entity with respect to liability, loss, or damage caused or > > alleged to be caused directly or indirectly by the instructions contained > > within this or related message(s). -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s).
