Venturi: A device for changing the velocity and pressure distribution within a flow wherein the pressure will decrease as the velocity increases and vice versa. This is the principle by which a carburettor works and is governed by Bernoulli's equation.

For carb balancing, a tapered tube with a large bung at the small end that fits into the carb mouth and has a pressure tapping at this end is sufficient to compare flows between carbs without actually having to use Bernoulli's equation. The pressure tapping is taken to a water manometer via a water trap ( a container capable of catching all the water in the manometer) as already suggested. Whilst pressure is proportional to the square of velocity, it is advisable not to rev up the engine with this connected!

This link gives you a good view of a commercial unit. I note that very little advertised now for new carb balancing equipment as FI has been around for so long.
http://cgi.ebay.co.uk/Gunson-Carbalancer-Carburettor-Balancing-Tool_W0QQitemZ180604222734QQcmdZViewItem?rvr_id=216970466193&rvr_id=216970466193&cguid=73f925cf1210a0aad3e4b2e4fe3415eb

Hamish

-----Original Message----- From: Ian Mac
Sent: Thursday, March 10, 2011 9:28 PM
To: Quantum Owners Group
Subject: [Quantum Owners] Re: Xtreme Heading for IVA- at last


Gents,

Thanks for the helpful and prompt replies: I am in Bristol, so not
very close to any of you, unfortunately.

1. I will round the edges of the hinges and hopefully that will be
sufficient.
2. I need to look at the IVA manual and the indicators closely as it
looks like I may have an issue there and need to move to the wings.
Andrew, are you saying the main indicators on stalks need to be
removed/ blacked out?  Do the side ones remain?  Can you confirm
location of them on the cycle arch- "rear of the ..wheel arches"?
(shouldn't they be on top of the arch to be seen from all around?)
3. Fog light and fog light wiring is okay.  Other issues already
picked up re. windscreen pillars, etc.
4. A bit worried about the windscreen issue as it is fitted, so I need
to look at IVA manual for wiper sweep, etc.
5. I am also planning to get the car "MOT'd" at a local garage before
IVA in order to check some basic issues re. integrity, driveability,
safety, braking, tracking, emissions, etc before driving down to IVA
test.
6. Air flow balance: Hamish, can you explain the Venturi water gauge
set up to me or do you have a photo?

Thanks again,

Ian Mac

--
You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en

IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s).




--
You received this message because you are subscribed to the Google Groups "Quantum 
Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/quantumowners?hl=en

IMPORTANT NOTE: All information presented herewith is provided on an "As Is" 
basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor 
the individuals associated with the Quantum Owners Club or in the preparation of the 
above information shall have any liability to any person or entity with respect to 
liability, loss, or damage caused or alleged to be caused directly or indirectly by the 
instructions contained within this or related message(s).

Reply via email to