Ian,

Yes Bristol is a bit far !

I used surface mount indicators only (Europa Spares - Universal side
repeaters, £14), this both avoided the need to drill and the issue of
hitting a wheel. The wire was tywrapped to the cycle wing frame and
just tucked around the corner, glued down as not to create an issue,
you may have gathered mine was a temporary solution,

On the scuttle, either remove or ensure no light can be seen, if they
are there they must be positioned correctly - I removed them and used
a full rubber grommet

As for location on the cycle wings, mine were just inside off the
rounded outside edge but still where the wing was almost horizontal -
this will depend on your arch fitting, also make sure that are not to
close to the ground.


Windscreen. consider a removal- its only 4 bolts and sealant. If you
have the fixing bars fibreglassed in, replacement is also fairly easy.
Use the bolts to fill the holes, remove the wipers and add nutcovers,
it doesn't matter about the washer jets, left over adhesive etc
remaining provided they are softened.  Oh, borrow a helmet, 60 mph +
with no helmet is hard work!

I found that with the QSC wipers set-up it is not possible to
guarantee full coverage and the modern alternative was to much ££ at
the time.

However, if the windscreen is super clean, with the rainx additive to
help, it might appear that the coverage is sufficient ??? Bit of a
gamble

Good luck,

Andrew



On Mar 10, 10:07 pm, Ian Mac <[email protected]> wrote:
> Been checking indicators again and I think I understand now: I need to
> remove the indicators from the scuttle and replace with some on the
> side of the cycle arch.
>
> Where did people buy these from as I need to make sure they are not
> too deep within the cycle wing?
>
> Ian Mac

-- 
You received this message because you are subscribed to the Google Groups 
"Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/quantumowners?hl=en

IMPORTANT NOTE: All information presented herewith is provided on an "As Is" 
basis, without warranty or the implication thereof. Neither the Quantum Owners 
Club nor the individuals associated with the Quantum Owners Club or in the 
preparation of the above information shall have any liability to any person or 
entity with respect to liability, loss, or damage caused or alleged to be 
caused directly or indirectly by the instructions contained within this or 
related message(s).

Reply via email to