在 2018年3月25日星期日 UTC+8上午7:54:49，Greg写道： > > Hi, hopes I'm not bothering you and thanks for your tips I finally got > > Qubes running on my MBP. However, I can't get the wifi card working using > > methods you discussed above, after running "sudo xl pci-attach sys-net > > '02:00.0,permissive=1'" (02:00.0 is the network controller pci address), > > sys-net still don't have the network controller attached and using "qvm-pci > > attach" still cause the system to freeze, how do you finish the attach > > phase? > > I now do the following to attach the BCM43602 to sys-net: > I disabled "Start qube automatically on boot" for sys-net and sys-firewall in > the qubes manager. I now manually start sys-net using "qvm-start sys-net" and > immediately after executing that command (well about 2 seconds later) I > execute "sudo xl pci-attach sys-net '03:00.0,permissive=1'" to attach the > device to sys-net while it is still starting up. It seems that I have to > attach the device to sys-net before it has fully booted, because if I attach > it too late it doesn't seem to be detected by the VM. > > Note that my particular BCM43602 has a PCI ID of 14e4:43ba which is supported > by the brcmfmac driver. Your particular device might need another driver (I > can't help with that I'm afraid).
That was...tricky, I'll have a try, hope to be successful. -- You received this message because you are subscribed to the Google Groups "qubes-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to qubes-users+unsubscr...@googlegroups.com. To post to this group, send email to qubes-users@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/qubes-users/113ae84f-660a-4593-9c7d-b3ecdacce3f4%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
