Vincent Gillet wrote:
> It works OK, but I do not have "Framed-IP-Address" in Start Packet.
> Only in Stop.
> This is a drawback because I cannot see IP-Address when I list connected
> users from online Radiator DB.
>
> Did you find any solution to have Framed-IP-Address before Stop packet ?
>
With "aaa accounting update newinfo" you will get an Alive packet (
deprecated in the Radius RFC ) with the Framed-IP-Address attribute.
If you are using the 11.3T branch there is a hidden command, "aaa
accounting delay-start". With this command you'll get the IP address in
the Start attribute like in any other NAS in the market, but remember
that it's an un-supported hidden command.
Félix
______________________________________________________________________
DATAGRAMA SERVICIOS INTERNET
C/ Acer 30 Tlf: +34 3 223 00 98
08038 BARCELONA ( Spain ) Fax: +34 3 223 12 66
mailto:[EMAIL PROTECTED] http://www.datagrama.net
______________________________________________________________________
ÿ
To unsubscribe, email '[EMAIL PROTECTED]' with
'unsubscribe radiator' in the body of the message.