It's the same with the verticle. It adjusts the form to the maxScreenSize
at runtime and removes the scrollBars that are present during designTIme.
----- Original Message -----
From: "Paul InterlockInfo" <[email protected]>
To: "RBASE-L Mailing List" <[email protected]>
Sent: Monday, December 21, 2009 6:08 PM
Subject: [RBASE-L] - Re: R:BASE eXtreme 9.0
My error! I was assuming "DB Slider" and Not the "AutoScroll" so I have to
take back 50%. The Slider does move! Scroll as in Autoscroll is a bit
different. I might add to Mikes comment, Mike could you check the vertical
scroll, I was also having an odd behavior in the vertical area as well.
Mike or Patrick can RDCC that one also.
Sincerely,
Paul D.
I did learn something today, dual monitors. Develop in native resolution
and slide it to the 600 x 800 and see it there. I tried several different
setting without any luck, using "OI"
Only loose icon positions :( Never had a reason till today!
-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of MikeB
Sent: Monday, December 21, 2009 4:13 PM
To: RBASE-L Mailing List
Subject: [RBASE-L] - Re: R:BASE eXtreme 9.0
As Karen said, when you check AutoScroll, the scroll bars are added as
necessary. It seems like even if I put an object on the form with a width
of say 1500 (with screen width of 1280) and set the form width in the
designer to 1600, save the form (at this point the horizontal scrollbar is
visible) then run the form, the ScrollBar is not visible and the form is
_Just_ the width of the screen. When I reopen the form in the designer, the
width has been reset to 1292.
I would recon you could open an incident with regard to this anomaly using
the method I explained previously.
