In a message dated 4/3/2010 10:10:59 P.M. Eastern Daylight Time, [email protected] writes:
I would have the axel that goes into the hull (the axel itself supported buy bronze bushings) bored out to 1/4" then grind flat spots on the torsion bar, couple of setscrews and your done, im pretty sure this is how the armortek guys do it. Chris. b i'm mounting mine to the bottom of the tank hull (at least that's the plan). i can see how mounting them inside the tank would allow the one end to pass through the side of the tank hull using a bushing, but the Tiger is 1:7th scale limiting some of the inside space - i'll have to take a look to see how much height there is for the motors and batteries, but IIRC that's why i was planing on mounting them on the outside of the hull Chris, _Odyssey Slipways_ (http://hometown.aol.com/odysseyslipways/index.html) -- You are currently subscribed to the "R/C Tank Combat" group. To post a message, send email to [email protected] To unsubscribe, send email to [email protected] Visit the group at http://groups.google.com/group/rctankcombat To unsubscribe, reply using "remove me" as the subject.
