We had an array that reduced output on 12 of 18 SW240w modules due to a nearby
lightning strike. Output dropped from 36v to 24v. Array was located at edge of
farm field and inverter in barn 100' away was also trashed.
Modules were potted, but homeowner's Nationwide made good on everything.
Bill Hennessy
Berks Solar, LLC
371 Centennial Rd
Mertztown, PA 19539
o 610 682 4300
c 484 560 4666
NABCEP certified installer
PA contractor #44411
www.berkssolar.com
________________________________
From: Jeff Irish <j...@hudsonsolar.com>
To: RE-wrenches <re-wrenches@lists.re-wrenches.org>
Sent: Tuesday, August 5, 2014 11:27 AM
Subject: Re: [RE-wrenches] [BULK] Diode Failure
We experienced a similar lightning event two years ago that destroyed over a
dozen modules. The system was a top of pole ground mount with four rows of
four poles each, sixteen in total, arranged in a square. The lightning strike
occurred 150 feet off the southwest corner of the array, where it hit a utility
pole. All the damaged modules were in the front or south most row, and
concentrated toward the southwest. The module J-boxes were melted and
deformed, with burned or exploded diodes. That was the only sign of damage to
the system. The utility lost at least one pole top transformer, and the
customer some appliances in his nearby farmhouse. Fortunately the inverters
were in a barn several hundred feet away. Being a top of pole mount, the
system was extensively grounded, with the steel poles at least 4 feet into the
ground and lines of bare # 6 copper connecting them and multiple ground rods.
Jeff Irish
Hudson Solar
Rhinebeck, NY
From:RE-wrenches [mailto:re-wrenches-boun...@lists.re-wrenches.org] On Behalf
Of Corey Shalanski
Sent: Tuesday, August 05, 2014 10:03 AM
To: RE-wrenches@lists.re-wrenches.org
Subject: [BULK] [RE-wrenches] Diode Failure
Wrenches,
We recently were contacted by a customer who reported a lightning strike close
to his house. His online monitoring revealed that 30 of 35 microinverters
simultaneously stopped producing power. On initial visit to the jobsite we
measured Voc on many modules - either 12V or 24V instead of rated 36V. On a
second visit we discovered that bypass diodes - either 1 or 2 corresponding to
observed voltage loss - had failed on each of the faulty modules.
My question is: Can anyone support the theory that a nearby lightning flash can
cause mass bypass diode failure?
--
Corey Shalanski
Joule Energy
New Orleans, LA
ᐧ
_______________________________________________
List sponsored by Redwood Alliance
List Address: RE-wrenches@lists.re-wrenches.org
Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive:
http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out or update participant bios:
www.members.re-wrenches.org
_______________________________________________
List sponsored by Redwood Alliance
List Address: RE-wrenches@lists.re-wrenches.org
Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive:
http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out or update participant bios:
www.members.re-wrenches.org
