Hey Chad E-Jot Makes a fastener for steel that's thread cutting (must be pre drilled) It also has a neoprene washer and stainless hardware.
Kind regards Tom Duffy Senior Solar Design Engineer [Real-logo-X-195] E-Mail: [email protected]<mailto:[email protected]> **Please note my new email - You will now be able to find me at: [email protected]<mailto:[email protected]> Please update your records so we don't lose touch!** Main Number: 888-826-0939 Panama Office: 507-836-5588 X 122 Direct Toll Free: 888-503-6772 International: 575-539-2111 X 122 SKYPE Address: thesolarbiz (e-mail first) NOTICE: Due to recent budget cuts, the rising cost of electricity, gas, and oil...plus the current state of the economy............the light at the end of the tunnel, has been turned off... It should have been solar. Confidentiality Notice: This message including any attachments is for the sole use of the intended recipient and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender and delete any copies of this message. From: RE-wrenches [mailto:[email protected]] On Behalf Of Chad Waits Sent: Monday, June 06, 2016 5:15 PM To: RE-wrenches <[email protected]> Subject: [RE-wrenches] Steel Trusses Wrenches, Anyone out there have any experience attaching arrays (from the topside) to roofs with steel trusses under plywood decking? We've got a new project that has steel trusses and we would prefer to not have to spend time in the attic bolting through (it was 113 degrees here today)... Is there a fastening system out there that anyone has experience with? Oh, the roof is composite/strengthened clay tile as well. Thanks! Chad Waits President/Owner - Net Zero Solar 101 W. 5th St., Tucson, AZ 85705 Office: 520-207-4053 Cell: 520-270-4873 NABCEP Certified PV Installation Professional NABCEP Certified Solar Heating Installer [cid:[email protected]]
_______________________________________________ List sponsored by Redwood Alliance List Address: [email protected] Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://www.mail-archive.com/[email protected]/maillist.html List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out or update participant bios: www.members.re-wrenches.org
