Chris and Jerry,
Sorry, I forgot to mention I did exactly that, had the
Fluke clipped to the + and (-) of the pack and watched it as load was
applied. Yes, voltage fell but never got below ~24.4V when the inverter
output stopped. Checked tightness of all battery connections, terminal
to terminal cables, virtually no corrosion anywhere. Also, inverter
stayed ON, just the output cut-out, then back on then off, then......
Bill
Feather River Solar Electric
Bill Battagin, Owner
4291 Nelson St.
Taylorsville, CA 95983
530.284.7849
CA Lic 874049
www.frenergy.net
On 10/18/2021 7:14 AM, Jerry Shafer wrote:
Look at the batteries, use a meter right at the bolts going in to the
inverter, sounds like low voltage cut out.
On Sun, Oct 17, 2021, 9:07 PM frenergy <[email protected]> wrote:
Hey Folks,
I haven't seen this one until yesterday. Customer with a
20 year old Trace SW4024 called. I've been servicing this reliable
system for the last 8 years. He said after a delay the power
shuts off
when a moderate load comes on after 5-15 seconds, then back on, then
off..... Light loads no problem, the power stays on. The inverter
stays on the entire time (yellow light and that famous audio buzz)
but I
hear a relay? inside the left side of the wiring section with each
change of on-off, off-on state. I assume its a repair to a service
shop. Ideas? Recommendations for repair shops? I haven't been
getting
a response from the Solar Cowboyz in Grass Valley.
Thanks,
Bill
Feather River Solar Electric
Bill Battagin, Owner
4291 Nelson St.
Taylorsville, CA 95983
530.284.7849
CA Lic 874049
solar powered since 1982
--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
List sponsored by Redwood Alliance
Pay optional member dues here: http://re-wrenches.org
List Address: [email protected]
Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
There are two list archives for searching. When one doesn't work, try the other:
https://www.mail-archive.com/[email protected]/
http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
http://www.re-wrenches.org/etiquette.htm
Check out or update participant bios:
http://www.members.re-wrenches.org
