We always did had to change out the shorter rods. And at hamfests, VHF WACOM duplexers being sold are often noted as having the "2-Meter" notch rods, etc. if they are all ready to go to 2-Meters. I moved this narrow split 151 MHz one to 144.79/145.39, and prior to that, to 147.74/147.14, and all needed the new notch rods. TX-RX is familiar with the correct ones to use, it's just that they're closed until Monday and we need the info before then, if possible. LJ
Original Message: ----------------- From: mch [EMAIL PROTECTED] Date: Fri, 02 Jan 2004 01:23:26 -0500 To: [email protected] Subject: Re: [Repeater-Builder] Need Help WACOM VHF Duplexer Info [EMAIL PROTECTED] wrote: > > To get it to move to 2-Meters with a 600 KHz split, we had to order three > new longer notch tuning capacitor brass tubes for one side How far down did you go? I think that's the same model I have that went to 146.37/.97 MHz fine. And I think it started life around 155 MHz, but that I don't recall with much certainty. I do know it was higher than 151 MHz. I didn't have to change a thing (except the tuning). Joe M. Yahoo! Groups Links To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ To unsubscribe from this group, send an email to: [EMAIL PROTECTED] Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/ -------------------------------------------------------------------- mail2web - Check your email from the web at http://mail2web.com/ . Yahoo! Groups Links To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ To unsubscribe from this group, send an email to: [EMAIL PROTECTED] Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
