Hi Reverse burst is ani-phasing of the pl for about 100ms.Only used on mechanical reed pl units as in the old micors.
Regards Brad ZS5WT --- ian wells <[EMAIL PROTECTED]> wrote: > the rev burst wasn't enabled but i tried it enabled > and nothing > happened.thanks for the sugestion > Thank you > Ian Wells > Kerinvale Comaudio > mail service 1017, > Biloela,4715. > www.kerinvalecomaudio.com.au > 1-email- [EMAIL PROTECTED] > 2-email- [EMAIL PROTECTED] > ----- Original Message ----- > From: "russ" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Saturday, July 24, 2004 10:47 AM > Subject: Re: [Repeater-Builder] tait t2010 > > > > Give this a try, > > Turn off the rev. burst. > > 73 Russ, > > ----- Original Message ----- > > From: "ian wells" <[EMAIL PROTECTED]> > > To: <[email protected]> > > Sent: Friday, July 23, 2004 6:17 PM > > Subject: [Repeater-Builder] tait t2010 > > > > > > > > > > hi guys > > > i am wondering if there is a way to setup or to > program a t2010 to > > transmit > > > a tail without the ctcss tail on the end of a > transmission (ie to be > used > > as > > > the transmitter in a a repeater so while the > receiver receives a signal > > it > > > activates the t2010 transmitter with a ctcss > ,and when the receive > signal > > > ceases the transmitter continues with a 1-2 > second tail without the > > > ctcss ).At the moment i have 2 t2010 connected > direct through so while a > > > signal is received the transmitter transmitts > with the ctcss > > > Thank you > > > Ian Wells > > > Kerinvale Comaudio > > > mail service 1017, > > > Biloela,4715. > > > www.kerinvalecomaudio.com.au > > > 1-email- [EMAIL PROTECTED] > > > 2-email- [EMAIL PROTECTED] > > > > > > > > > > > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > > > > > > > > > > > > > Yahoo! Groups Links > > > [EMAIL PROTECTED] > > > > __________________________________ Do you Yahoo!? New and Improved Yahoo! Mail - Send 10MB messages! http://promotions.yahoo.com/new_mail Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
